Lcd Display - Philips HD3620 Mode D'emploi

EnglisH
20
Problem
The appliance makes a
sound.
The pump goes on
frequently when I am not
pouring beer.
tap unit
It is difficult to place the
tap unit onto the keg.
It is difficult to press the
release buttons to remove
the tap unit.
It is not possible to place
the keg with the assembled
tap unit in the appliance.
The tube cannot be
removed from the tap unit.
It is difficult to place the
tube into the tap unit.

lcD display

There is a green dash
on the display and the
appliance does not work.
There is a green or red
dash on the display and the
background light flashes.
4222.001.9361.3.indd 20
Solution
Remove the tap unit and tube and reinstall them. If the problem continues
to occur, contact the PerfectDraft call centre in your country to obtain a
new tube.
Because the appliance chills constantly, the fan works continuously.
The pump may go on while you pour beer to maintain the right pressure.
When you are not pouring beer, the pump also goes on every now and
then to keep the appliance at the right pressure.
Reinstall the tap unit and tube. If this does not help, try another keg
together with a new tube. If the problem continues to occur, contact the
PerfectDraft call centre in your country.
Make sure no old beer is left in the tap unit. Clean the entire tap unit with
hot water and, if necessary, some washing-up liquid.
First remove the keg from of the appliance. Then press the release buttons
to remove the tap unit from the keg.
Beer residues may cause the tap unit to stick to the keg. Clean the tap unit
with hot water and, if necessary, some washing-up liquid to dissolve beer
residues. Then remove the tap unit from the keg.
Make sure the tap unit is placed correctly on the keg. Push the tap unit
down firmly when you place it onto the keg. See chapter 'Preparing for
use', section 'Placing the tap unit onto the keg'.
Check if you have lifted the blue locking levers properly and push them
down after you have installed the keg.
Remove the tap unit first before you remove the tube. Rinse the tap unit
with hot water. Press the tube release button and pull the tube out of the
spout.
Make sure the tube is placed correctly (see chapter 'Preparing for use',
section 'Placing the tube into the tap unit').
Make sure you clean the tap unit with hot water before you insert a new
tube.
The tube may be broken. Contact the PerfectDraft call centre in your
country to obtain a new tube.
Make sure that the tap unit is placed correctly (see chapter 'Preparing for
use', section 'Placing the tap unit onto the keg').
Remove the tap unit, clean it and reinstall the tap unit. If this does not help
try another keg with a new tube.
08-02-10 10:52