Philips HD3620 Mode D'emploi page 16

EnglisH
16
4222.001.9361.3.indd 16
3 Tilt the keg with the assembled tap unit towards you and take it out
of the appliance.
4 Press on the release buttons on both sides of the tap unit (1). The
tap unit is released from the keg with a click and you can remove it
(2).
You have to remove the tap unit from the keg before you can replace the
tube.
Always replace the tube when you install a new keg. Never use a tube for
more than 30 days.
5 Hold the tap unit over a sink.
6 Press the blue tube release button to release the tube.
7 Pull the tube connector out of the tap unit and remove the flexible
tube out of the tap body.
Always clean the tap unit with hot water and, if necessary, some washing-
up liquid before you insert a new tube.
8 Assemble the tap unit onto the keg (see chapter 'Preparing for
use', section 'Placing the tap unit onto the keg').
9 Insert a new tube into the tap unit (see chapter 'Preparing for use',
section 'Placing the tube into the tap unit').
10 Place the new keg into the appliance (see chapter 'Preparing for use',
section 'Placing the keg into the appliance').
08-02-10 10:52