Philips HD3620 Mode D'emploi page 10

EnglisH
10
4222.001.9361.3.indd 10
2 Slide the projections of the tube connector under the hinge points.
3 Push the tube connector into the opening in the tap unit ('click').
Placing the keg into the appliance
Never place the keg into the appliance if you have not assembled the tap
unit and the tube properly. See sections 'Placing the tap unit onto the
keg' and 'Placing the tube into the tap unit' in this chapter.
1 Slide the release button to the right to open the doors.
2 Lift the two blue locking levers completely.
3 Tilt the keg with the assembled tap unit slightly forward and put it
into the appliance.
- First put the keg on the cooling plate of the appliance.
- Then put the keg upright by sliding the tap unit between the blue
locking levers.
08-02-10 10:52