Télécharger Imprimer la page

Toro 51460 Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

3. If there is any cutting line left (there should be a
short piece) remove and discard it.
4. Thoroughly clean the cutter head. Inspect for any
damaged or worn parts.
5. If you want to wind new line onto the old spool,
complete the following steps:
Hook one end of line into the slot on the
spool, allowing no more than 1/8 inch to
protrude, pushing the end of the line all the
way to the inner end of the slot.
Wind the line in the direction of the arrow on
the spool, in level rows, between the spool
flanges.
Note: The trimmer will not function correctly if the
line is wound in the wrong direction, the end of the
line protrudes more than 1/8 inch, or the line is
wound beyond the outer edges of the spool.
6. Unwind no more than three inches of line from
spool (either new or re-wound). Hold line and spool to
prevent unraveling.
7. Holding the line and
spool to prevent
unraveling, place the
cap on the spool.
8. Insert line into
eyelet, aligning the cap
tabs with the slots in the
cutter head
9. Press in the tabs
and push down the cap
and spool to lock the
cap in place.
Note: The spool may need to be rotated slightly to
allow it to be fully installed.
The fully installed cutting
head should appear as
illustrated.
6
Maintenance
After each use of the trimmer, complete the following
procedures:
Wipe the trimmer clean with a damp cloth. Do
not hose the trimmer down or submerse it in
water.
Wipe or scrape clean the cutter head and spool
area any time there is an accumulation of dirt or
cuttings.
Check and tighten all fasteners. If any part is
damaged or lost, repair or replace it.
Scrape debris away
from air intake
vents.
Important: Keep the air intake vents free of grass
and debris to prevent the motor from overheating.
Storage
For idle periods of more than a month, disconnect the
charger from the wall outlet and trimmer after the
trimmer is fully charged. Do not store the trimmer with
the charger plugged in. Storing trimmer in a warm
area will decrease life of battery. If the trimmer must
be stored in a warm area, charge battery for 24hours
every 2–3 months when not in use.
Service
Toro has designed this product to give you years of
trouble free use. Should it need service, take the
product to your Authorized Toro Service Dealer. Your
Toro Dealer is specially trained to fix Toro products
and will ensure that your Toro stays "All" Toro.
Disposing of the Battery
When the battery no longer holds a charge, you can
purchase a new battery and have it installed at your
Authorized Service Dealer. If you want to discard the
trimmer, remove and recycle the battery before
discarding the trimmer.
3326-955

Publicité

loading