Settings - Enerdis ULYSCOM ETHERNET MODBUS TCP Manuel Utilisateur

Settings

This area is reserved to Administrator.
This section allows to display and change ULYSCOM ETHERNET settings.
Parameters area
IP Address ULYSCOM ETHERNET IP address specification. It has to be a valid number coherent with LAN/Intranet (the
default value is 192.168.1.253). To configure more than one ULYSCOM ETHERNET, perform one per time
and assign different name and IP for each device.
Subnet Mask
Mask of the subnet that involves the ULYSCOM ETHERNET.
Gateway Gateway IP connected to the ULYSCOM ETHERNET for communication through different networks.
Primary DNS Primary DNS server address.
Secondary DNS
Secondary DNS server address.
Protocol
This setting is fixed and cannot be modified. Protocol selection.
NTP Time Server
NTP time server address.
UTC Time Correction Time correction respect to UTC (accepted values: -12...+13).
FW Version
ULYSCOM ETHERNET firmware version.
HW Version
ULYSCOM ETHERNET hardware version.
Serial Number
ULYSCOM ETHERNET serial number.
Change key It allows to change the current parameters.
Default key It allows to restore the default settings. A confirming message is displayed. Press Yes and then enter
Administrator Username and Password.
Services area
Date and time
ULYSCOM ETHERNET date and time.
SSH Socket Secure Shell.
Change key
It allows to change ULYSCOM ETHERNET date and time.
Enable key
Enable a secure channel for remote assistance by technical support service. After enabling, always carry
out a reboot by pressing Reboot key.
Web server • ULYSCOM ETHERNET
33