Application Areas Of The Multifunction Accessories; Blade Assembly - SilverCrest SSMM 600 A1 Mode D'emploi

6.7 Application areas of the
multifunction accessories
Preparing food:
• Rinse or wash the food.
• Cut the food up into smaller pieces.
• Remove the outer shell from nuts. You
may use the inner skin if you wish, e.g.
with almonds.
• Use fresh herbs without stems and in a
dry condition.
• Remove sinews, bones and gristle from
the meat.

Blade assembly

The blade assembly 14 is ideal for chop-
ping meat, Parmesan, vegetables, fruit, nuts
and herbs.
1. Fill the food into the container 15 and
close it with the drive cover 8.
2. Place the motor unit 1 onto the drive
cover 8 until it engages.
3. Connect the mains plug 3 with the wall
socket.
4. Press the controller 2 to switch the de-
vice on and release it to switch off.
5. After chopping remove the mains
plug 3 and remove the motor unit 1
from the drive cover 8.
6. Figure H: press the button 16 and
turn the drive cover 8 anticlockwise to
open the container 15. Lift the drive
cover 8 off, when the marking
the handle 17 points to the attachment
marking 32.
7. Clean the device immediately if possible.
Slicing insert and grating disk /
dicer attachment
The slicing insert/grating disk 20 is used to
cut or grate raw fruit and vegetables such as
cucumbers, onions, mushrooms, apples, car-
rots, radishes, potatoes, courgette and cab-
bage.
The dicer, consisting of the blade assem-
bly 11 and disk insert 12, is suited to dice
raw fruit and vegetables such as onions, ap-
ples, carrots, potatoes and courgette.
1. Close the container 15 with the drive
cover 8 (see "Multifunction drive cover"
on page 29).
2. Place the motor unit 1 onto the drive
cover 8 until it engages.
3. Connect the mains plug 3 with the wall
socket.
4. Press the controller 2 to switch the de-
vice on.
5. Fill food into the refill opening 9. If nec-
essary, use the food pusher 7 to careful-
ly push the food down.
6. When you are finished, let go of the
controller 2.
7. After cutting, grating or dicing pull out the
mains plug 3 and remove the motor unit 1
from the drive cover 8.
8. Figure H: press the button 16 and
turn the drive cover 8 anticlockwise to
open the container 15. Lift the drive
cover 8 off, when the marking
31 at
the handle 17 points to the attachment
marking
9. Clean the device immediately if possible.
31 at
32.
33
GB