Siemens DE04101 Notice De Montage Et D'utilisation page 22

Water connection
The appliance is only approved for heating water
■
with a specific electric resistance of ≥ 1 300 Ωcm
at 15 °C. Your water utility company can give you
information about the specific water resistance.
Installation
Ensure the axial fit of the connection pipes in the
■
nozzles.
Tighten the union nuts on the nozzles with an
■
open-end wrench and counter hold with a suit-
able open-end wrench.
The T-piece (for the pressurized connection)
■
and flexible connection hose are available
commercially.
pressurized (closed)
22
en
■
■
Controlling temperature
The supply temperature (probably lower in winter)
and pressure fluctuations can influence the tem-
perature of the water leaving the tap.
■
■
F2
F1
Use an unpressurized tap for the unpressurized
connection, e. g. the tap available as a special
accessory (Single-lever mixer tap BZ13061,
Two handle fixture BZ13051).
Exchange the perlator from the tap fixture with
the supplied aerator to change the spray pattern
of the tap.
Turn the valve slowly in the closed direction for
higher temperatures (F1).
Add cold water for lower temperatures (
unpressurized (open)
F2).
F2
F1