Filter Reset; Storage; Troubleshooting - Philips 800 Série Mode D'emploi

2
Pull the filter out from the appliance� Discard the used filter (fig d)�
3
Remove all packaging materials of the new filter (fig e)�
4
Put the filter into the appliance (fig f)�
5
Reattach the base and rotate it clockwise to fasten the base (fig g)�
6
Put the plug of the air purifier in the power socket�
7
Press the power
8
Press and hold for 3 seconds to reset the filter lifetime counter�
9
Wash your hands thoroughly after replacing the filter�

Filter reset

You can replace the filter even before filter replacement alert (
After replacing a filter, you need to reset the filter lifetime counter manually�
1
Press the power button
2
Within 10 seconds after power on, press and hold the mode switch button
5 seconds to reset the filter lifetime counter�

6 Storage

1
Turn off the air purifier and unplug from the power socket�
2
Clean the air purifier, air quality sensor and the surface of the filter (see chapter
"Cleaning")�
3
Let all parts air dry thoroughly before storing�
4
Wrap the filter in air tight plastic bags�
5
Store the air purifier, filter in a cool, dry location�
6
Always thoroughly wash hands after handling a filter�
7

Troubleshooting

This chapter summarizes the most common problems you could encounter with the
appliance� If you are unable to solve the problem with the information below, contact the
Consumer Care Center in your country�
Problem
The appliance does not
work even though it is
plugged in�
EN
8
button to switch on the appliance�
to turn on the appliance�
Possible solution
• The filter replacement alert is on but you have not replaced the
corresponding filter� As a result, the appliance is now locked� In
this case, replace the filter and reset the filter lifetime counter�
) displays on the screen�
for