Analysing The Sample - Dräger DrugTest 5000 Manuel Technique

Masquer les pouces Voir aussi pour DrugTest 5000:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.6

Analysing the sample

1. Make sure that the Analyzer is switched on and in ready to
measure state.
2. Take the test cassette from the test person.
3. Open the Analyzer door
and insert the test cassette
into
the
lower
compartment
of
Analyzer, until it you hear it
click into place.
4. Insert the cartridge into the
upper compartment of the
Analyzer, until you hear it
click into place.
5. Close the door of the Analyzer. The Analyzer will start the
evaluation automatically.
Do not move the unit while performing the test!
A status bar on the display indicated the progress of the
evaluation process.
Optional:
Depending on configuration, enter the following data, follow
instructions on the display:
Enter test person data.
Enter user data.
Once the analysis is complete the Analyzer emits an acoustic
signal.
To show results follow the instructions on the display.
6. Open the door of the
Analyzer and remove the
test
cassette
with
cartridge attached from the
lower compartment of the
Analyzer.
7. Close the door of the analyzer.
The analysis results are shown on the display.
Dräger DrugTest 5000 Test System
the
the
Optional:
Print test result.
Save data record.
8. Confirm results by pressing the
The Analyzer is ready for the next measurement.
04023950.eps
04123950.eps
04223950.eps
Use
-key.
OK
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières