Checking The Battery Capacity - Dräger CMS Notice D'utilisation

Preparing for use
6.2

Checking the battery capacity

Move sliding switch to position 1.

The analyzer performs a self-test.
All display elements are activated:

The battery voltage is checked during the
self-test:
4 battery symbols (see example)
= batteries fully charged;
corresponds to approx. 450 minutes of
measurement.
1 battery symbol
= batteries must be replaced as their
capacity is too low for further
measurements.
The analyzer switches off when the battery voltage has dropped below the minimum capacity
(display: Battery empty).
Fit new batteries, page 40.
Move sliding switch to position 0.

Dräger CMS Analyzer
0 0
1 1
2 2
3 3
function test
please wait
01122837_4en.eps
00922837.eps
01022837.eps
41