Publicité
en Transportation, storage and disposal
Water is leaking or the filter container
is full of water.
The water inlet hose or the water outlet
hose is not connected correctly or is dam-
aged.
Check the installation of the water hoses.
In the event of damage, call customer
service.
Little or no residue in the filter con-
tainer.
The programmes that are used produce
few microplastics.
No action required.
The filter net is damaged.
Check the filter net.
In the event of damage, call customer
service.
The washing machine displays a
pump fault.
The appliance poses an additional flow res-
istance that can be detected as a fault.
Check whether the installation conditions
have been met.
The washing programme has been
cancelled.
The water inlet hose is not correctly con-
nected or is kinked.
Check the installation of the water inlet
hose.
The programme duration is extended
significantly.
The water inlet hose or the water outlet
hose is too long.
Use only the supplied water hoses or
genuine spare hoses.
The draining height is too high.
Do not exceed the maximum draining
height of 100 cm for the water outlet.
Page 8
The water drain hose is sagging too much.
Ensure that the water drain hose does
not sag by more than 10 cm.
Noises after the programme has
ended.
Not a fault. The appliance self-cleaning
function is active.
No action required.
10
Page 9
Page 7
Page 8
Transportation, storage and
disposal
and
storage
Transportation,
disposal
Removing the appliance
Note: Have a towel and a bucket ready to
catch any residual water.
1. Unplug the appliance's mains plug.
2. Disconnect the water inlet hose and the
water outlet hose from the appliance.
If you want to continue operating the
washing machine, connect the washing
machine properly.
3. Hold the filter container by the recessed
grip and remove it fully to the front.
4. Unscrew the two locks on the underside
of the filter housing above the sink or
bucket.
Fig.
14
5. Swivel the filter housing until the water
has drained completely.
6. Attach the two locks to the underside of
the filter housing.
7. Slide the filter container into the filter
housing from the front.
Disposing of the old appliance
Valuable raw materials can be reused by
recycling.
1. Remove the appliance.
2. Dispose of the appliance in an environ-
mentally friendly manner.
Information about current disposal meth-
ods are available from your specialist
dealer or local authority.
This appliance is labelled in
accordance with European
Directive 2012/19/EU con-
cerning used electrical and
electronic appliances (waste
electrical and electronic
equipment - WEEE).
The guideline determines the
framework for the return and
recycling of used appliances
as applicable throughout the
EU.
Customer Service
Service
Customer
Note: Under the terms of the manufac-
turer's warranty the use of Customer Ser-
vice is free of charge.
Page 10
Publicité
