Publicité
autorisée aux deux conditions suivantes : 1)L'appareil ne doit pas produire de brouillage;
2)L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement. IC WARNING Cet équipement est
conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement
non contrôlé. L'utilisateur fi nal doit suivre les instructions spécifi ques pour satisfaire les
normes. Cet émetteur ne doit pas être co-implanté ou fonctionner en conjonction avec
toute autre antenne ou transmetteur. Le dispositif portatif est conçu pour répondre aux
exigences d'exposition aux ondes radio établie par ledéveloppement énergétique DURABLE.
Ces exigences un SAR limite de 1,6 W/kg en moyenne pour un gramme de tissu. La valeur
SAR la 0.733W/kg plus élevée signalée en vertu de cette norme lors de la certifi cation de
produit à utiliser lorsqu'il est correctement porté sur le corps.
FCC Requirement Changes or modifications not expressly approved by the party
responsible for compliance could void the user' s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation. Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures: – Reorient or relocate the receiving antenna. – Increase the separation between
the equipment and receiver. – Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. – Consult the dealer or an experienced
radio/TV technician for help. FCC WARNING This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. End user must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter. The mobile
device is designed to meet the requirements for exposure to radio waves established by the
Federal Communications Commission (USA). These requirements set a SAR limit of 1.6
W/kg averaged over one gram of tissue. The highest SAR value reported under this
standard during product certification for use when properly worn on the body is 0.733 W/kg.
For body operation, this device has been tested and meets FCC RF exposure guidelines
when used with any accessory that contains no metal and that positions a minimum of
15mm from the body. Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
03/
Introduction
Le MUCAR CDE900 a été développé par l'esprit le plus distingué de l'industrie. Il est
spécialement conçu pour prendre en charge les 10 modes de service OBDII, y compris les
données en direct, le test de la sonde O2 et plus encore, sur les voitures, les SUV, les
camionnettes et les mini-vans conformes à l'OBDII/EOBD vendus dans le monde entier depuis
1996.
04/
Description du produit
Bouton d'alimentation/verrouillage de l'écran
❶
Publicité
